  |
|---|
 |
CLEARANCE |
|
|
Capri 815 Mother Board Fan Error Problem [ The Solution ]
This Problem Occurs Due to the Fan
Installed is not having the sensor which reports the mother board that
the fan is running. There are three wires in the fan connector which is
connected to the mother board. The yellow wire is the one having sensor, some
fans does'nt have the feature of sensor.
Note : Normally all the Intel(R) Original Fans Have the feature of sensor support. If any other fan is installed which does'nt have the sensor support , then it will show the fan error in the first boot. The Diagnosis of this error can be solved by disabling the fan sensor in the mother board. This sensor is Located in one of the Fan Connectors, and the sensor can be disable by making a jumper in the two pins out of the three pins in the fan connector [ See below Pictures ].This two Pins to install jumper should be the second and the third pins from the Power supply connector. Leaving the First Pin Blank. See Below the photographs of the motherboard showing where to put the jumper so that it will not show u the
fan error. In brief the jumper should
be Installed just near the power supply connector which u see in
the following pictures. Leaving the first pin from power supply connector side u need to put the jumper in 2nd and 3rd pins. See The Jumper Installed Just near
the Power Supply Connector. See The Jumper Installed Just near
the Power Supply Connector. |
| |||||||||||||
